Omega OHPD800W, Инструкция по установке и эксплуатации, Страница: 12 / 20

12 User Manual OHPD800W
Troubleshooting
For Serious Faults:
•
If you experience one of the listed faults shown in the table
on page 13, or if another emergency or serious fault occurs,
immediately power off the dryer using the controls, and then
disconnect the power from the source.
•
If a serious fault occurs, DO NOT attempt any repairs
yourself, instead wait for a service agent to do so.
•
For assistance or to organize an authorised service agent
contact our After Sales Support by calling 1300 11 4357,
or by emailing support@residentiagroup.com.au.
•
Please note that if a service agent is asked to attend whilst
the product is under warranty and finds that the problem is
not the result of an appliance fault, then you may be liable for
the cost of the call out charge.
•
The appliance must be accessible for the service agent to
perform any necessary repair. If your appliance is installed in
such a way that a service agent is concerned that damage
will be caused to the appliance or your home, then they will
not complete a repair.
•
Please refer to the Warranty Information to learn more.
Problem Solution
The display is not turning on.
• Check if the mains power plug has been properly inserted and the power is on.
•
Check if there is a power outage in your home or area. If the problem persists
contact our Support Team for guidance.
The symbol is lit on the display.
•
Check the water container. If it is full, pour out the condensate water, reinsert the
water container and then restart the dryer.
• If the icon is still appearing despite the water container being empty, we
recommend that you contact our Support Team for guidance.
The symbol is lit on the display.
•
Check the lint filter. Carefully remove the filter and clean the accumulated lint.
After reinserting the filter, restart your dryer.
•
If the icon is still appearing despite the lint filter being clean, we recommend
that you contact our Support Team for guidance.
The drying program is not starting.
• Check if the mains power plug has been properly inserted and the power is on.
•
See if the water container is full. Additionally, check if the lint filter is clean.
• Ensure that the dryer door is properly closed, and no garments are snagged.
•
Restart the dryer, however if the problem persists contact our Support Team.
The drying program either took too long or
the clothes were not dry enough.
• See if the water container is full. Additionally, check if the lint filter is clean.
•
Consider using a higher drying intensity level, or alternatively use the Time Dry
program to extend the time clothes are spent drying.
• Ensure you are not attempting to dry over the appliance ’ s maximum capacity.
There are humming noises while running.
•
The compressor is operating. This is normal and does not indicate a fault.
The dryer turns off after a program ends. • This is normal, as the appliance turns off automatically in order to save energy.
For Minor Faults