INSTALLATION OF BUILT IN COOKTOP
In order to prevent leakage of any liquids on the work bench and fix the
Cooktop
to the
bench, a special sealing tape is supplied together with your oven. Place the cooktop glass
down on a clean cloth on a stable flat surface & apply this seal around the bottom edge of the
cooktop (see below). Remove the backing from the sealing tape and then place the
Cooktop
in position. If the sealing tape is not enough to fully seal the
Cooktop
to the bench, use a
small bead of clear high temperature resistant silicone sealant.
This
Cooktop
can be installed into a workbench 30-40mm thick. When cutting the hole in
the work bench, keep in mind the correct space and ventilation which are shown in the
diagrams below.
A board must be placed a minimum of
20mm below the cooktop that prevents
anyone from touching the underside of the
cooktop. Take care that there is adequate
ventilation for air exchange to the inductive
elements (at least 20mm).
NOTE: INDUCTIVE COOKTOPS GENERATE A
LOT OF HEAT INTERNALLY WHEN IN
OPERATION. THE BOTTOM OF THE
COOKTOP
MUST HAVE A CLEAR PATHWAY
TO VENT THIS HEAT OUT VIA THE BOTTOM
FANS TO THE OPEN AIR IN ORDER TO KEEP
ITSELF COOL. FAILING TO PROVIDE
ADIQUATE VENTILLATION WILL DAMAGE
THE
COOKTOP
AND VOID YOUR
WARRANTY. THE ABOVE DIMENSIONS
SHOULD BE CONSIDERED THE MINIMUM
VENTILLATION REQUIRED.
4
