Omega OBO960X1, Инструкция по эксплуатации

Страница: 19 / 22

19
Cleaning and Maintenance
NOTE : Cleaning and maintenance operations must only be carried out when the oven
is cool.
The appliance should be disconnected from the power outlet or turned off at your
isolation switch before commencing any cleaning process.
Cleaning the oven exterior:
Before starting to clean your oven, be sure that all control buttons are off and your appliance has
cooled. Unplug the appliance.
Do not use cleaning materials containing particles that might scratch the enamelled and painted
parts of your oven. Use cream cleaners or liquid cleaners, which do not contain particles. As these
cleaners may damage the surfaces, do not use caustic creams, abrasive cleaning powders, rough
wire wool or hard tools. In the event of any excess liquids spilling over your oven surface during
cleaning, clean up immediately so as to prevent possible damage to the enamel or metal surface.
Do not use steam cleaners for cleaning the oven.
Cleaning the interior of the oven:
Make sure to unplug the oven before starting to clean it. You will obtain best results if you clean
the oven interior while the oven is slightly warm (the oven should not be operating). Remove the
side wire racks first. Wipe your oven with a soft piece of cloth (e.g. dish cloth) dampened with
warm soapy water after each use, rinse cloth in warm water then wipe oven again and finish by
wiping with a dry cloth. It is also recommended to wipe clean the oven door and rubber seal. For a
complete cleaning process, use dry and powder type oven cleaners, following the oven cleaning
product’s instructions.
OVEN LAMP REPLACEMENT
•
The appliance must first be disconnected from the power outlet or turned off at your
isolation switch.
•
Unscrew the glass cover attached to the lamp holder; anti-clockwise.
•
Pull out the lamp and replace it with another high-temperature lamp with the following
Type: E14
Voltage: AC220V-240V
Wattage: 15W Temperature rating: 300°C
•
Remount the glass cover and reconnect the appliance to the power supply
NOTE: Should you experience any difficulty please contact your nearest after-sales service
centre.