Omega OBO650X2, Инструкция по эксплуатации

Страница: 10 / 24

7
Operating Instructions
Controls
OVEN FUNCTION/WARNING LIGHT CONTROL
The oven function/warning light control button is used to select the different functions. Each is explained in
detail. To select a function, turn the control knob to the desired oven function and then set the temperature
with the thermostat control.
OVEN THERMOSTAT CONTROL
The oven thermostat control is used to select the desired temperature for cooking. When the temperature
inside your oven reaches the value set, the thermostat will cut the circuit and the thermostat light will go off.
When the temperature falls below the set value, the thermostat will again be turned on alongside the
thermostat light. It is normal for this to occur during the cooking process, particularly when the door has
been opened.
Function Selector Thermostat Control
8
Operating Instructions
Oven Functions
Defrost Function
You can start the defrost operation by putting the frozen food into oven and bringing the
function control knob to the indicated mark. This function will not cook/bake the food; it only
helps to defrost it within a short time.
Put the food to be defrosted on the wire rack that you will place on the middle rack support from
the bottom (Figure 13). To collect the water that accumulates due to the melting ice, insert an
oven tray onto a lower rack. This function is perfect for finishing off the defrost process for
frozen food that has been in the refrigerator from the evening before and may not be completely
thawed out.
Fan Forced Function
This Fan Forced function uses the turbo heater (located in the back of the oven) to evenly
disperse the heat in the oven. This function is suitable for cooking multiple dishes on various
oven shelves. Adjust the function control knob so it indicates the Fan Forced function symbol.
Adjust the thermostat control knob of your oven to a temperature recommended on the cooking
table for the cooking operation you wish to perform.
Preheating of the oven for about 10 minutes is recommended. Place the food in a suitable
container, then place into oven and cook for the required time.
If you are going to cook using two trays at the same time, while adjusting the cooking
temperature, select the temperature that is the lowest among the levels suitable for your food of
choice, as shown on the table.
Cooking with two trays requires additional cooking time compared to cooking with one tray.
Usually, the food on each tray does not finish at the same time so you may need to take the tray
of cooked food out of the oven, and continue the cooking operation for the remaining tray.
After cooking, turn off the oven function and temperature control knobs and cancel the timer
program if in use. Take the cooked food out of the oven and place it in a safe heatproof surface.
As the oven will be hot, work near with caution and keep children away from the cooling oven.
Full Grill Function
This function is used for grilling. Adjust the function control knob so it indicates the Mid-Grill
function symbol and adjust the oven timer to the recommended time for cooking. Set the oven’s
thermostat control knob to the required temperature. After a preheating period of 10 minutes,
put your food into the oven. For grilling, put the food on the grill rack and sit into the tray. Place
the tray on the highest shelves (11/12). Placing the rack within the oven tray provided will
ensure that any marinade, fat or oil dropping from the food will be collected. When grilling, the
oven door must be closed. On this function, the middle heating elements/coils of the grill
operate.
This setting is ideal for toasting bread, cheese melts and melting cheese topped dishes or
finishing off a dish to lightly brown on the surface. Also used for herb and garlic bread.
After cooking, turn off the oven function and temperature control knobs and cancel the timer
program if in use. Take the cooked food out of the oven and place it in a safe heatproof surface.
As the oven will be hot, work near with caution and keep children away from the cooling oven.
16
Troubleshooting
If you still have a problem with your appliance after checking these basic troubleshooting steps,
please contact an authorised service person or qualified technician.
Problem Possible Cause Solution
Oven does not switch on. Power is switched off.
Check whether there is power supplied.
Also check that other kitchen appliances
are working.
No heat or oven does not warm
up.
Oven temperature control is
incorrectly set.
Oven door has been left open.
Check that the oven temperature control
knob is set correctly.
Oven light (if available) does not
operate.
Lamp has failed.
Electrical supply is disconnected
or switched off.
Replace lamp according to the
instructions.
Make sure the electrical supply is
switched on at wall socket outlet.
Cooking is uneven within the
oven.
Oven shelves are incorrectly
positioned.
Check that the recommended
temperatures and shelf positions are
being used.
Do not frequently open the door unless
you are cooking things that need to be
turned. If you open the door often, the
interior temperature will be lower and this
may affect the results of your cooking.
The timer buttons cannot be
pressed properly.
There is foreign matter caught
between the timer buttons.
Touch model: there is moisture
on the control panel.
The key lock function is set.
Remove the foreign matter and try again.
Remove the moisture and try again.
Check whether the key lock function is
set.
The oven fan (if available) is
noisy.
Oven shelves are vibrating.
Check that the oven is level.
Check that the shelves and any bake ware
are not vibrating or in contact with the
oven back panel.
The cooling fan continues to
operate after the oven is
switched off.
Electronically-controlled oven fan
automatically runs for a certain
amount of time to cool the oven.
The fan switches off automatically when
the electronic components have cooled
sufficiently.
The oven has switched itself off.
Electronically-controlled ovens
switch off automatically if no
function is in operation.
The oven will switch itself off automatically
to save energy if no other action is taken
within a certain time frame after switching
it on or after the end of a cooking
programme.
If the door is opened during a
fan-assisted function, the internal
fan will stop.
Electronically-controlled ovens
with a door switch will stop
cooking if the oven door is
opened.
It is a normal operation of the appliance,
useful when cooking foods in order to
avoid excessive heat escaping. When the
door is closed, the oven will restart to
normal operation.
7
16
Troubleshooting
If you still have a problem with your appliance after checking these basic troubleshooting steps,
please contact an authorised service person or qualified technician.
Problem Possible Cause Solution
Oven does not switch on. Power is switched off.
Check whether there is power supplied.
Also check that other kitchen appliances
are working.
No heat or oven does not warm
up.
Oven temperature control is
incorrectly set.
Oven door has been left open.
Check that the oven temperature control
knob is set correctly.
Oven light (if available) does not
operate.
Lamp has failed.
Electrical supply is disconnected
or switched off.
Replace lamp according to the
instructions.
Make sure the electrical supply is
switched on at wall socket outlet.
Cooking is uneven within the
oven.
Oven shelves are incorrectly
positioned.
Check that the recommended
temperatures and shelf positions are
being used.
Do not frequently open the door unless
you are cooking things that need to be
turned. If you open the door often, the
interior temperature will be lower and this
may affect the results of your cooking.
The timer buttons cannot be
pressed properly.
There is foreign matter caught
between the timer buttons.
Touch model: there is moisture
on the control panel.
The key lock function is set.
Remove the foreign matter and try again.
Remove the moisture and try again.
Check whether the key lock function is
set.
The oven fan (if available) is
noisy.
Oven shelves are vibrating.
Check that the oven is level.
Check that the shelves and any bake ware
are not vibrating or in contact with the
oven back panel.
The cooling fan continues to
operate after the oven is
switched off.
Electronically-controlled oven fan
automatically runs for a certain
amount of time to cool the oven.
The fan switches off automatically when
the electronic components have cooled
sufficiently.
The oven has switched itself off.
Electronically-controlled ovens
switch off automatically if no
function is in operation.
The oven will switch itself off automatically
to save energy if no other action is taken
within a certain time frame after switching
it on or after the end of a cooking
programme.
If the door is opened during a
fan-assisted function, the internal
fan will stop.
Electronically-controlled ovens
with a door switch will stop
cooking if the oven door is
opened.
It is a normal operation of the appliance,
useful when cooking foods in order to
avoid excessive heat escaping. When the
door is closed, the oven will restart to
normal operation.
16
Troubleshooting
If you still have a problem with your appliance after checking these basic troubleshooting steps,
please contact an authorised service person or qualified technician.
Problem Possible Cause Solution
Oven does not switch on. Power is switched off.
Check whether there is power supplied.
Also check that other kitchen appliances
are working.
No heat or oven does not warm
up.
Oven temperature control is
incorrectly set.
Oven door has been left open.
Check that the oven temperature control
knob is set correctly.
Oven light (if available) does not
operate.
Lamp has failed.
Electrical supply is disconnected
or switched off.
Replace lamp according to the
instructions.
Make sure the electrical supply is
switched on at wall socket outlet.
Cooking is uneven within the
oven.
Oven shelves are incorrectly
positioned.
Check that the recommended
temperatures and shelf positions are
being used.
Do not frequently open the door unless
you are cooking things that need to be
turned. If you open the door often, the
interior temperature will be lower and this
may affect the results of your cooking.
The timer buttons cannot be
pressed properly.
There is foreign matter caught
between the timer buttons.
Touch model: there is moisture
on the control panel.
The key lock function is set.
Remove the foreign matter and try again.
Remove the moisture and try again.
Check whether the key lock function is
set.
The oven fan (if available) is
noisy.
Oven shelves are vibrating.
Check that the oven is level.
Check that the shelves and any bake ware
are not vibrating or in contact with the
oven back panel.
The cooling fan continues to
operate after the oven is
switched off.
Electronically-controlled oven fan
automatically runs for a certain
amount of time to cool the oven.
The fan switches off automatically when
the electronic components have cooled
sufficiently.
The oven has switched itself off.
Electronically-controlled ovens
switch off automatically if no
function is in operation.
The oven will switch itself off automatically
to save energy if no other action is taken
within a certain time frame after switching
it on or after the end of a cooking
programme.
If the door is opened during a
fan-assisted function, the internal
fan will stop.
Electronically-controlled ovens
with a door switch will stop
cooking if the oven door is
opened.
It is a normal operation of the appliance,
useful when cooking foods in order to
avoid excessive heat escaping. When the
door is closed, the oven will restart to
normal operation.