Step 7: Slide another Wood Shelf Assembly which includes a
Susan
,
Pole Susan Bearing
, and
Decorative Cap
, on to the bottom
of the
Center Pole
. If the parts were assembled outside of the
cabinet, tilt the Pole and Susan Assembly and insert it into the
cabinet at this time.
Step 8: Slide the bottom of the
Center Pole
into the
Base Mount
Bearing
lining up the notch in the
Center Pole
with the pro-
trusion in the
Base Mount Bearing
(make sure the
Center
Pole
is seated all the way down).
Step 9: Holding the
Center Pole
down in position, slide the
Extension
Pole
into the
Top Mount
(make sure it is all the way in) and
tighten the
Height Adjustment Screw
on the
Center Pole
.
Step 10: Rotate all the
Wood Susan Shelves
until they detent. Rotate
the
Center Pole
until the Wood SusanShelves are in the de-
sired position, aligned with the front of the cabinet.
Step 11: Carefully lift the bottom shelf and add two additional
#8 x 3/4”
Truss Head Screws
in the
Base Mount Support
and make
sure all the screws are tight.
Step 6: Slide the
Pole Mount Bearing Assembly
back down and
press on to the
Retaining Pin
by lining it up to the slot in the
Pole Mount Bearing Assembly
. Tighten the screw on the
Pole Mount Assembly
making sure it is on the same side
as the
Height Adjustment Screw
. Note: The
Pole Mount
Bearing Assembly
can be positioned at any random height
by removing the
Retaining Pin
and using the screw on the
side of the
Pole Mount Bearing Assembly
. Make sure it is
TIGHTLY
screwed down.
Repeat Steps 5&6, If you are installing a 3 Shelf Unit.
Screw
Height Adjustment Screw
Form OME-006, 09/2004
©Omega Industries, Inc.
Step 5: Install a Wood Shelf Assembly, which includes a
Wood
Susan
Shelf
,
Pole-Susan Bearing
, and
Decorative Cap
, by slid-
ing it onto the
Center Pole
from the bottom. Follow this with
the
Pole Mount Bearing Assembly
and slide it up the
Cen-
ter Pole
above the holes and insert a
Retaining Pin
in one
of the three holes in the
Center Pole (choose the specific
hole for the height desired)
.
Step 4: Put the
Decorative Caps
on the top of the
Pole-Susan Bear-
ings
that are attached to the Wood Susans.
Step 3: Fasten the
Top Mount
to the cabinet top with all Four
#8 x 1/2”
Truss Head Screws
.
The next steps can be done inside the cabinet or outside the cabinet if
there is room to maneuver the complete assembly into the cabinet.
Step 3
Step 4
Step 5
Step 6
Step 9
Step 8
Содержание Kidney Shaped Susan
Страница 3: ......