Omega HH931T, Руководство пользователя

Страница: 12 / 49

Preparation for Use
2-5
4. If present, carefully remove old batteries being careful to not damage the battery
contacts;
5. Observing proper polarity, install three (3) new, AA alkaline (IEC LR6, ANSI 15)
batteries;
6. Re-install the battery cover and two (2) retaining screws;
7. At initial power on after battery replacement, allow approximately 30 seconds for
instrument to stabilize.
Figure 1: Battery Installation
Making Your First Temperature Measurement
OMEGA’s 900 Series Data Thermometers are designed for easy operation, while still
providing a feature-rich experience via the intuitive user interface.
To get started making temperature measurements right away, follow these steps:
1. Perform Section 2.5, Battery Installation and Replacement;
2. Connect a compatible temperature probe to the Channel 1 and/or Channel 2 input
connector located at the top of the instrument;
To ensure best measurement accuracy, allow several minutes for the
thermocouple probe and connector to thermally stabilize after
connection to the instrument.
3. The instrument will immediately display a temperature measurement for the
connected channels. However, to ensure valid and best accuracy measurements,
continue to Step 4 below;
4. Set the desired measurement parameters as follows:
a. Enter the Setup Menu by pressing , hold the key down for
approximately 1.5 seconds, and then release it;
Retaining
Screws
Battery
Compartment
Gasket