Step 1 - While the system in the armed condition, enter via the driver's door. Be aware that
the system will activate when the door is opened, sounding the siren, flashing the parking
and dome lights, and locking the doors should the door entered be closed again before
disarming the system.
Step 2 -
Using your key, turn the ignition "on". The following step must be performed
within the next 10 seconds.
Step 3 -
Press the valet switch equal to the number programmed for stage #1; the factory
setting is one. If the factory default setting of 1 and 0 presses is retained, press and
release the valet switch once and the system will instantly disarm. The disarming will
be accompanied by two siren chirps.
If stage #2 presses have been programmed, the system will not disarm, but pause and
chirp the siren before continuing to sound. When a stage #2 entry is required, at this point
the stage #2 entry must be made within 10 seconds. If both stage's entries are correct, the
system will disarm shortly after the stage #2 entry. After a failed attempt to achieve
Selectable Code Override, the ignition switch must be turned "off", then "on" again before
another attempt is made. See pages 25-26 for further information on the Selectable Code
Override.
Once the system is disarmed, if Valet Mode is desired, just press and hold the Valet
Switch for 2 seconds to place the system into Valet Mode. Remember, if the Selectable Code
Page - 15
