Omega DP25B-S, Руководство пользователя

Страница: 42 / 68

4
Configuring The Meter
32
4.6.3 Assigning Setpoint 1 Values to Net or Gross Readings
1. Press the MENU button until
S1.CF
displays, then press the
∂
TARE button twice.
or
Press the
∂
TARE button from
S.2
.
The meter shows one of the following:
•
S.3=N
Setpoint 1 assigned to net reading (Default)
•
S.3=G
Setpoint 1 assigned to gross reading
2. Press the
ß
NT/GRS button to toggle between available choices.
3. Press the MENU button to store your selection(s). The meter momentarily shows
STRD
, followed by
S2.CF
(Setpoint 2 Configuration).
4.7 USING SETPOINT 2 CONFIGURATION
S2.CF
Refer to Table 6-1 for a summary list of menu configuration.
Setpoint 2 Configuration
S2.CF
is not active unless your meter has dual relay output
capabilities. The LED's will display whether the
S2.CF
is active or not. You may use
Setpoint 2 Configuration
S2.CF
for the following:
• To set the setpoint's active band above or below your chosen value
• To select whether the setpoint operation is latched or unlatched
• To assign setpoint values to the net or gross reading
4.7.1 Setting Setpoint 2's Active Band
1. Press the MENU button until the meter shows
S2.CF
.
or
2. Press the
∂
TARE button. The meter shows one of the following:
•
S.1=A
(Active above the setpoint) (Default)
•
S.1=B
(Active below the setpoint)
3. Press the
ß
NT/GRS button to toggle between available choices.
4. Press the
∂
TARE button to select if Setpoint 2 is latched/unlatched or press the
MENU button to store your selection. The meter shows
S1.DB
.
Note
☞