Fig:E
JUMPER POSITION
Unscrew cover of DB-PASS-23A unit.
Place jumper as seen below:
TO ECM SIDE
IGNITION
ORANGE - +12VOL
TS CONSTANT
BLACK -
GROUND
VIOLET - DA
TA OUTPU
T
VIOLET -
NO CONNECTIO
N
Pass-Key III
Module
P
K
3
N.C
GREY
CONNECTOR
BLACK
ORANGE
VIOLET
PINK
VIOLET
-
DATA TO ECM
RED
-
N/C
PINK
-
NC
VIOLET/TRACER - N/C
BROWN
-
CONNECT TO (-) IGNITION OUTPUT WIRE OF REMOTE START SYSTEM
GREEN
-
N/C
BLUE
-
N/C
PINK
/
TRACER - NC
ORANGE
-
+12 VOLTS CONTANT
BLACK -
CHASSIS GROUND
Programming LED
Programming Jumper
NOT USED
SEE FIG. E
PINK - IGNITION
ORANGE -
ORANGE - +12VOLTS CONSTANT
BLACK - GROUND
BLUE
FUEL ENABLE LINE
VIOLET - DATA OUTPUT
GREY - LED
Pass-Key III
Module
P
K
3
VIOLET - N/C
PINK - IGNITION IN
VIOLET/TRACER - N/C
GREEN
-
N/C
BLUE -
FUEL ENABLE LINE
PINK
/
TRACER - IGNITION OUT
Programming LED
Programming Jumper
IMPORTANT:
DO NOT CONNECT VIOLET
DATA OUTPUT WIRE OF INTERFACE MODULE
TO VEHICLE DATA WIRE (PIN 2) UNTIL EVERY
OTHER WIRE HAS BEEN CONNECTED & THE
HARNESS HAS BEEN PLUGGED INTO THE
DATA BUS INTERFACE (DL) MODULE.
When the DB-PASS-23A harness is correctly installed:
Place the programming jumper to the “PROGRAMMING” position.
(See
urn to the “ON” position.
The LED will blink 4 times to confirm sucessful programming.
Turn key to the “OFF” position.
Remove the programming jumper and put it to
position
-
INSTALL 2 PROGRAMMING
FIG:A)
Place key in ignition and t
“OPERATING“
(See FIG:B)
Programming Position
Operating Position
Fig:A
Fig:B
A
A
B
B
(LED)
(LED)
INSTALL 2
GM PASSKEY3 (Pk3)
GREY
CONNECTOR
TO ECM SIDE
BROWN
-
CONNECT TO (-) GROUND OUTPUT
WHEN RUNNING WIRE OF REMOTE START SYSTEM
INSTALL 3
GM PASSKEY3 (Pk3)
BLACK - CHASSIS GROUND
RED
-
N/C
ORANGE
-
+12 VOLTS CONTANT
NO PROGRAMMING NECESSARY
NOTE: PLACE JUMPER AS SHOWN IN
FIG:E
BEFORE CONNECTING MODULE.
INSTALL 3:
TECH NOTES:
*Vehicles with the ignition cylinder located on the dash: Yellow, Black & White wires can be
found coming from the ring of the cylinder - Trace these wires to the factory PK3 module located just abov
the gas pedal area.
GM PASSLOCK II & PASSKEY III INTERFACE MODULE
DB-PASS-23A
D
B
P
A
S
S
-2
3
-A
REMOTE START
MODULE
REMOTE START
MODULE
DB-PASS-23A Installation Instructions
