CL3515R K/J/T/E/R/S/N/L/U/B/C Calibrator Thermometer
2. Calibrate Out
Adjust output in real time.
Value
Set the output vale.
Send
Press
“
Send” CL3515R send out the output setting vale.
3. Auto Send
Group Item
Group 0 to Group 9.
Step Item Send
Step Item 0 to Step Item 9.
Forward
Select step forward.
Backward
Select step backward.
12
CL3515R K/J/T/E/R/S/N/L/U/B/C Calibrator Thermometer
1. Power button “
”
The “ ” button turns the thermometer on or off. When entering REC mode, the
power off function is disabled.
Remark: The meter will run self calibration when the meter starts.
The measuring leads and calibration wires must be removed before
taking measurements, and you can get accurate calibration values.
2. Button “°C/°F/°K”
Press the °C/°F/°K button to cycle through temperature scale, °C, °F and °K.
3. Type Selection (thermocouples)
Press the “type” button and the selected symbol will blink which means in the setting
mode.
Press “
” button to make right shifts to cycle through
K
→
J
→
T
→
E
→
R
→
S
→
N
→
L
→
U
→
B
→
C
→
mV.
Press “
” button to make left shifts to cycle through
K
→
mV
→
C
→
B
→
U
→
L
→
N
→
S
→
R
→
E
→
T
→
J.
Press the “type” button again to choose the selected thermocouple.
4. Backlight “ ” button
Pressing the button less than two seconds to turn on and pressing the button again less
than two seconds to turn off the backlight in the LCD. It will turn off after thirty
minutes without operation.
Auto power off
It is in the APO mode when the meter is turned on and will turn off the meter without
operation for fifteen minutes. Pressing the “ ” button over two seconds to cancel the
function. And pressing the “ ” button again to activate the APO function.
5. “REL” button
The relative value function can be used for comparing the saved reference value with
other measurements. Press the “REL” button less than to store the current
measurement as the reference value, and press the “REL” over two seconds to disable
the function.
6. “HOLD” button
When HOLD mode is selected, the thermometer holds the present readings and stops
all further measurements. To activate the data hold mode, press the HOLD button,
and “HOLD” is displayed on the LCD. Pressing the HOLD button again cancels the
function, and the instrument will automatically resume measurements. When the Hold
key is activated, it will stop functions of the other entire key except Power and
Backlight.
5
