Omega Altise OMC15E1, Инструкция по установке и эксплуатации

Страница: 5 / 8

WARNING: DO NOT USE THE HEATER ON
THE FLOOR WITHOUT MOUNTING THE
FEET.
– Insert the plastic shaft of the castors into the
feet supports.
– Insert the feet support on each side of the
heater using the built-in clips.
OPERATION
Please read instructions before
using the heater.
(1) Ensure that the Thermostat Control Knob
is on ‘Snowflake’. Make sure the ON/OFF
switch is off.
(2) Plug the power cord into a suitable
electrical outlet (Rated not less than 13
amp)
(3) Turn the ON/OFF switch to on.
(4) The heater will operate by default in
MANUAL mode and ‘Display’ will show
the room temperature and ‘MANUAL’
symbol…… If ‘ON’ and ‘OFF’ time have
been set, the ‘ON’ and ‘OFF’ symbols will
be displayed.
(5) For the heater to start operating, the user
must select a power, ‘Power 1’, ‘Power II’
or ‘Power I+II’. The indicator lights PI and
PII show the power selected. If PI+PII are
on, power in use is PIII.
(6) Choose a thermostat knob position set
at a higher temperature than the room
temperature. In a short time, heat will
come out of the heater.
You can adjust the thermostat temperature
from 5 to 32 degrees Celsius anytime while
the heater is turned on. Select temperature
by turning the knob clockwise (higher
temperature) and anti-clockwise (lower
temperature). When the room temperature
reaches the selected temperature, heater
will turn off automatically.
(7) Press ‘MODE’ button to set and use the timer.
(8) To set the timer, press MODE once. LCD
screen displays the clock 00:00, glittering.
Press +/- to set the time, press the keys
once, minutes will scroll up or down one
by one, keep the keys depressed and
minutes will scroll up or down in 10 minute
increments. Once you set the desired time,
press the SET button to confirm it, the LCD
will stop glittering.
(9) To set the heater to start working, go to
the ‘ON TIME’ mode. The LCD displays
the clock 00:00, glittering. Press +/- to set
the time, press the keys once, minutes will
scroll up or down unit-by-unit, keep the
keys depressed and minutes will scroll up
or down in 10 minute increments. Once
you set the desired ‘ON TIME’, press the
‘SET’ button to confirm it, the LCD will
stop glittering.
(10) To set the time for the heater to stop
working, go to the ‘OFF TIME’ mode.
The LCD displays the clock 23:59
glittering. This is the default OFF time.
Press +/- to set the time, press the keys
once , minutes will scroll up or down
unit-by-unit, keep the keys depressed
and minutes will scroll up or down in 10
minute increments. Once you set the
desired ‘OFF TIME’, press the ‘SET’
button to confirm it, the LCD will stop
glittering.
(11) It is possible to choose the working
power for a specific ‘ON/OFF’ time.
Select a ‘Power I’, ‘Power II’ or ‘Power
I+II’ button,then press ‘SET’ button to
confirm. If ‘ON/OFF’ times are already
saved, the program will start using the
last power confirmed. If there are no ‘ON/
OFF’ times saved, after confirming the
power do again steps 8 and 9 above.