1
0
MLM-300
B2
ASSEMBLY INSTRUCTIONS
C6
FOR ASSEMBLY SEE P17.1
D16
B2
C5
D17
C6
A7
C5
A7
M10X25L ROUND BOLT X2
M10 PSRING WASHER X2
The tread side should be outward
Assemble
Direction
AP
D18
NOTE:
1. THE BELT SMOOTH SIDE SHOULD ATTACH ON
PULLEY SURFACE, AND THE BELT SMOOTH
SIDE WRAP AROUND THE BELT RETAINER
SHAFT (N)
2. PLEASE BE SURE THE PRESSURE
BETWEEN THE BELT CLAMPS (K) DO
NOT EXCEED 70 PSI
Adjust Belt Procedure:
1. Lift the selector rod a little and then insert the pin between first weight stack
and top plate (Do not insert though the first hole of the rod), and there are
10 mm gap between top plate and first weight stack.
2. Adjust the belt to have proper tension and then tighten the belt clamps
3. Remove the pin and let the top plate fall on the first weight plate.
Detect the distance
5
MLM300-022010
Figure 5
Above shows STEP 10
assembled and completed
Page
17
