omega altise
3
Assembly Instructions
1. Remove all items of packaging from the fan.
2. Insert the pedestal tube into the base plate. Carefully turn
the unit upside down and secure with the L shaped
locking screw as shown in Figure 1. Return to an upright
position.
Figure 1.
Locating lugs
3. Loosen the height adjustment ring and extend the
support pole. Initially the support pole will be held tightly
in place. If necessary, use a pair of pliers to grasp the
support pole and pull it into position.
Figure 2.
4. Retighten the height adjustment ring to
prevent slipping, then place the fan
assembly (control panel and motor
casing) onto the pole and tighten the pole
screw manually. Do not over tighten.
5. Remove the blade cap from the motor
shaft by turning it clockwise. Then remove
the locking nut by turning it anti-clockwise.
6. Place the rear grille into position, ensuring that it is aligned
with the locating lugs (see Figure 2). If this is done
correctly, the carry handle on the grille will be at the top.
7. Fix the grille into position by replacing the rear grille locking
nut tightly by hand. Do not force the locking nut (see Figure
2).
Figure 3.
8. The groove in the centre of the fan blade aligns with the T-
bar on the motor shaft to ensure it is positioned correctly.
9. Fix the blade into place by gently hand tightening the blade
cap onto the motor shaft in an anti-clockwise direction (see
Figure 3). Do not over tighten.
10. Open all locking clips on the front grille (see Figure 4).
Figure 4.
11. Place the front grille into position and secure it by fastening
the clips over the outer rim. The small screw and nut at the
bottom of the grille must be fitted for additional safety. (see
Figure 5).
Figure 5.
