HEAT LIVE RELAX
CONTROL FUNCTIONS
GETTING STARTED
1.
Carefully remove the heater from packaging and the carton, and unwind the cord to its full length.
2.
Either fit the castors
and wheels then
place the heater onto a stable, flat and dry surface, or fit the mounting
brackets to a stable
wall & hang from the wall in a dry position away from open or running water. See
installation sections for
details.
3.
Turn the heater off at the power switch (on the top right hand side of the unit). Plug the cord set into a
220-
240V~A.C. 50Hz electrical outlet. Turn the power on at the electrical outlet.
4.
Turn the heater on at the power switch (on the right hand side of the unit). Depending on the last setting, either
the numeric display will light up showing the previous temperature setting (the appliance will start to operate), or
the numeric display decimal point will light up (the appliance in stand-by mode). If in stand-by mode, press the
power button to start the appliance, and press again to put back to stand-by mode.
NOTE: Heater must have castors fitted or be attached to a wall before use.
1.
Power On/Off Button
2.
Mode Button - Temperature/ Timer
setting
3.
Up Button
4.
Down Button
5.
Temperature/ Timer Display
6.
Power Indicator
7.
Heater Operation Indicator (Red)
8.
Delay Off Timer Set Indicator
(Green)
9.
Constant Frost Protection Indicator
10.
Lock Indicator
11.
Degrees Celsius Indicator
12.
Time Indicator
13.
Tilt Warning Indicator
14.
Vent, Warm Air Discharge
15.
240 Volt Power Cord and Plug
16.
Air Inlets
17.
Castors
and Wheels
A. Control Panel Console
B. Digital LED Display
