HEAT LIVE RELAX
SAFETY FEATURES
1.
A thermal overload protector is built in to prevent overheating. When an overheat temperature is reached, the
heater will automatically shut off. It can only resume operation when the user resets the unit (see reset instructions
below).
To reset your heater:
Unplug the heater and wait for 45 minutes for the unit to cool down. Then, turn on the unit again and operate
normally.
2.
The appliance has a tilt switch built into it so that if the appliance falls over, the element will stop working.
To reset your heater:
Turn the appliance off at the main power switch. Right the appliance back onto its castors NOTE: Take care as the
appliance may be hot. Turn the power switch on.
CLEANING & MAINTENANCE
WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING, DO NOT
IMMERSE HEATER IN WATER!
With the heater disconnected from the power, clean the exterior body of the heater with a soft damp cloth.
Always make sure that the heater is completely dry before connecting back to the mains supply. A vacuum
cleaner can be used to clean the inlets & outlets of dust & fluff. To clean behind a wall mounted unit, the
mounting clips can be disconnected & the heater rotated slightly forward (a 2 person job). Please make sure the
unit is properly resecured after.
CAUTION: Do not use gasoline, benzene, thinner, harsh cleaners, etc. as they will damage the heater. NEVER
use ALCOHOL OR SOLVENTS.
STORAGE: Store the heater with these instructions in the original packaging, in a cool, dry place.
WEEE WARNING
This product should not be disposed of with household waste. Please recycle where facilities exist and
check with your local authority for recycling advice.
SPECIFICATIONS
MODEL
INPUT POWER
RATED POWER DIMENSIONS (NO CASTORS) WEIGHT
, N.W G.W
OAPE1800B/W
220-240Vac
50Hz
1
8
00W
77
5
x4
40
x
8
5
mm (WxHxD)
6
Kg
, 7.2Kg
Attach the supplied right angle mounting brackets to the underside of the heater (front hole of bracket) using
the rear most of the pre installed case screws as shows in the diagram.
Check for strength.
Carefully place the heater (slightly tilted
forward) onto the hooks at the bottom of the
bracket & rotate back so the clips fix back into
their original holes. Check that they are fixed
correctly. If possible, have a second person
help to check for alignment as the heater is
attached. The heater is now ready to connect
to the mains power.
