OMEGA ALTISE
-frost Mode indicator (D4) will light up. This mode
eating. The Fan Mode indicator (D5) will light up.
There are 6 settings available on the appliance. Press the Mode button to cycle through them.
-
Anti-frost mode: When this mode is selected, the Anti
keeps the room temperature at 7
⁰
C.
-
Fan mode: This mode runs the fan only, with no h
-
Low Heating mode: The elements will run (with fan) at the lowest power setting. The Power indicator (D2)
will display the small bar to the left.
-
Medium Heating mode: The elements will run (with fan) at the medium power setting. The Power indicator
(D2) will display the small bar to the left and the central bar.
-
High Heating mode: The elements will run (with fan) at the highest power setting. The Power indicator (D2)
will display all 3 bars.
-
ECO mode: The selection of the heating mode is automated and will vary depending on the room
temperature.
MODES
When running any of the 3 heating modes, the thermostat temperature can be set using the Decrease Function
button (C6) and Increase Function button (C7). Press one of the buttons so the Temperature/Timer indicator
(D1) flashes and then continue to press until the correct temperature is displayed. The new temperature is set
when the display stops flashing. The appliance will run in the mode set until the room temperature reaches the
displayed temperature (thermostat temperature), and then go into standby until the temperature drops.
For greater economy, use high power initially and then turn down to low power when the required temperature
is reached. Please note that the fan speed remains the same when changing heat setting; only the heating
elements are adjusted.
The selection of the power mode can be automated by selecting the ECO mode (only when one of the 3 heating
functions has been selected). The appliance measures the room temperature, compares it to the set temperature
and calculates the optimum power level to run at. Press the ECO Mode button (C4) to select and the ECO Mode
indicator (D3) will light up. Press again to disable the function.
To adjust the display between Celsius & Fahrenheit, first turn the appliance on and press and hold the Increase
Function button for a few seconds until one of the Celsius/Fahrenheit indicators flashes. Press the Increase
Function button again to select the other Celsius/Fahrenheit indicator, and wait until it stops flashing.
HEATING
Press the Oscillation button (C5) and the appliance will start oscillating from side to side. Press again to stop.
OSCILLATION
When the power is turned on and the main power switch is turned on, an auditable beep is made and the
Standby indicator (D7) will begin to flash.
Turn the appliance on by pressing the On/Standby button (C1) and it will start operating using the last settings
(press again to turn off appliance).
D1
Temperature/Timer indicator
D2
Power indicator (L/M/H)
D3
ECO Mode indicator
D4
Anti-frost Mode indicator
D5
Fan Mode Indicator
D6
Celsius/Fahrenheit indicators
D7
Standby indicator
D8
Hour/Minute Indicators
D9
Timer indicator
①
⑤
③
④
②
⑨
⑥
⑦
⑧
