AirWatt - Installation and operating manual
Introduction
External heat recovery system AirWatt is intended for professional use. This user manual
provides all necessary information for dimensioning, installation, safe operation and
maintenance. It should be read thoroughly and carefully. Obey all safety instructions.
Manual should be conserved through entire lifetime of device. Regular and correct
maintenance and regular safety checks are required for long and trouble free operation.
Installation and use may be subject of local laws and directives which must be obeyed. For
any further information or in case of doubt contact manufacturer. Manufacturer will not be
held responsible for any defects, which are consequence of misinterpreting user manual
instructions, unprofessional installation or disobeying local laws and directives.
General safety instructions
Warning!
Operating this device may be dangerous, if following instructions are
not obeyed. In addition to this manual instructions from compressor
manufacturer must also be observed.
AirWatt unit was designed and manufactured in accordance with all health and safety
requirements of EU.
•
All personnel involved at installation, operating and maintenance of this device must
reed and fully understand this included instructions.
•
Installation and assembly of the unit can only be performed by authorized personnel
of company Omega Air d.o.o. Ljubljana.
•
Device may only be used in accordance to this manual.
•
Personnel must always wear personal protective equipment.
•
Do not use this device, if there are present any signs of damage or defect.
•
Always turn of compressor, lock the power supply and depressurize the system,
before performing any kind of work on device or installation.
•
Device must have installed limiting elements, which prevent operating outside
specified parameters.
•
It is forbidden to approach device under operation.
Installation and maintenance work on the device my only be carried by authorized and
trained professional.
•
It is forbidden to alter the device or its construction in any way.
•
Before maintenance depressurise the system.
•
Use only original spare parts.
•
Use the device only for the purpose for which it was originally designed.