Omcan RE-CN-0045-HC-BK, Инструкция по эксплуатации

Страница: 10 / 56

10
Troubleshooting
SYMPTOMS POSSIBLE CAUSE
Compressor will not start Check if the power cord has been plugged in.
Check for blown fuse.
Maintenance
• When loading the unit:
- Be careful not to block the air duct located at the back and the fan on the ceiling of the unit with contents.
- Blocking the air flow may cause decrease in performance.
- For the best performance, maintain at least 4 inches of clearance between the contents and the air duct.
• Set the shelves that come with the unit to fit your needs.
• Temperature controller:
- The controller is located at the right, front corner of the ceiling, or on the front bottom panel.
- To adjust temperature please refer to the manual of temperature controller.
• Do not leave the unit door open for long period of time. For the most efficient operation, close the door
immediately after the use.
ICE ACCUMULATION MAY OCCUR IN FREEzERS
• Try to reduce the amount of time the freezer doors remain open to prevent ice accumulation.
• Keep door seals clean to prevent air leakage.
• Scrape off any ice accumulated or try manual defrost mode.
Installation
IMPORTANT!!!PLEASE READ BEFORE INSTALLATION
• The refrigeration system operates most efficiently when installed in an area with cool, dry air circulation.
• There must be at least 6 inches of clearance on both sides and the back of the cabinet.
• Select a location away from the heat and moisture generating equipment such as stoves, ovens, etc.
• Avoid direct sun rays.
• Be sure that the floor where you intend to install that unit is strong and level enough to support the total
weight of the unit and its contents.
• To minimize shock and fire hazards, be sure that the unit is properly grounded. For your safety and
protection, all units are equipped with a special three-prong grounding plug on the service cord.
• All units are designed for indoor use. Outdoor use may cause significant damage to the unit.