Omcan J-110, Инструкция по эксплуатации, Страница: 5 / 20

5
General Instructions
Assembly and Disassembly
• Always make sure juicer cover is latched securely in place before motor is turned on. Do not unfasten the
latches while the juicer is in operation, or when the cutter plate is turning.
• NEVER use a damaged machine.
• Do not continue operation if your juicer malfunctions or is dropped or damaged in any manner. Call Omcan
Inc. at 1-800-465-0234 for assistance.
• NEVER return your juicer without authorization from a Omcan representative.
• Do not put your fingers or other objects into the juicer opening while it is in operation.
• If food becomes lodged in the opening, use the good pusher or another piece of fruit or vegetable to push
it down. When this method is not possible, turn the machine
OFF
,
UNPLUG
, and disassemble the juicer.
Remove remaining produce and clean the cutter plate and filter.
• SAVE THESE INSTRUCTIONS.
ASSEMBLING YOUR OMCAN COMMERCIAL JUICE EXTRACTOR
1. Prepare / use a certified sanitation solution that is food grade compliant. Always follow the directions on the
container.
2. Install the juice pan by placing the spout through an opening in the tower. Point the spout in the direction
you wish your juice to be served. Do not touch the inside of the juice pan.
3. Install the filter and cutter plate. Place the cutter plate inside the filter. Align the center hole over the center
hub, and lower the parts into the juice pan. Make sure both parts are seated properly on the hub.
4. Make sure the motor shaft is dry, and hand tighten the blade nut on the motor shaft. Hold the screen
filter and use the wrench to tighten the blade nut an additional ¼ turn clockwise, securing the blade/filter
assembly. Do not store the blade nut on a wet motor shaft over night.
5. Store the wrench. Clean the wrench and return it to its storage place near the juicer. This wrench is
specially designed to be used with your Omcan.
6. Wrap a dry dish towel around the base to cover the power switch and power cord. Set a waste container
under the juice pan spout. Spray approximately 1 pint of the sanitizing solution around the perimeter of the
filter screen, inside the filter screen, and onto the cutter plate and blade nut. Once done, remove the dish
towel and thoroughly dry the base.
7. Replace the top. Hold the top over the filter and align the latch strikes with the latches on the tower of the
juicer. Carefully lower the top onto the juicer body until it is resting on the tower.
8. Lock the latches. Hook the inner latch attached to the tower over the latch strike on the top. Assure proper
alignment of the latch to latch strike. Lift both the outer latch arms together until the latches lock in place.
Ensure even tension on both latches. You should hear an audible SNAP sound when properly adjusted.
9. Insert the pulp pipe into the pulp spout of the lid. The pulp pipe is held in by a thumb screw. Use your hand
to adjust the screw, it should be adjusted so that the pipe can stay in firmly in place.
10. With receptacles under the juice spout and pulp pipe, spray 1 quart of sanitizing solution down the feed
chute while the juicer is running. Follow by rinsing the sanitizing solution from the juicer by spraying one
quart tap or distilled water into the feed chute while the motor is running. Allow the juice pan to drain.
Dispose of the waste solution.