Omcan FR-CN-0150, Инструкция по эксплуатации

Страница: 6 / 20

6
Safety and Warranty
TRANSPORTATION AND PLACEMENT
• When transporting the chest freezer from one place to another, the inclination of the cabinet should not
exceed 45 degrees, for prevention against compressor or system damage.
• Before use, remove all the packing material. The back side of the cabinet should be more than 20cm away
from the wall, both flank sides more than 20cm.
• The freezer should be put in well-ventilated, dry place. Don’t use it under direct sunshine. The freezer
should be kept away from water sink, heat source and any volatile, corrosive material.
POWER SOURCE AND TEST-RUNNING
• Specified capacity of the wire is 7A. Section squares of the wire is 0.82mm2. Single line or compound
lines are all allowed. The fuse of 2.5A specified electric current should be installed. (Power cord should be
replaced with the same of 7A and 0.82mm2, when it is damaged).
• Single-phase power supply, 60Hz, voltage range 98~132V. If the voltage is unstable, please install a
voltage stabilizer with capacity above 1000W.
• Avoid turning on and off the power too frequently. If the power is turned off, wait an interval of 5 minutes
before turning it on again.
• When the freezer will be out of use for a long time, disconnect the power first, then clean it. Please
examine the circuit whether it is excellent before reuse.
RESIDENTIAL USERS: Vendor assumes no liability for parts or labor coverage for component failure
or other damages resulting from installation in non-commercial or residential applications. The right
is reserved to deny shipment for residential usage; if this occurs, you will be notified as soon as
possible.
1 YEAR PARTS AND BENCH WARRANTY
Within the warranty period, contact Omcan Inc. at 1-800-465-0234 to schedule a drop off to either
an Omcan authorized service depot in the area, or to an Omcan Service warehouse to repair the
equipment.
Unauthorized maintenance will void the warranty. Warranty covers electrical and part failures, not
improper use.
Please see https://omcan.com/disclaimer for complete info.
WARNING:
The packaging components are classified as normal solid urban waste and can therefore be disposed of
without difficulty.
In any case, for suitable recycling, we suggest disposing of the products separately (differentiated
waste) according to the current norms.