![background image](http://html1.mh-extra.com/html/omcan/fr-cn-0005/fr-cn-0005_instruction-manual_4510799008.webp)
8
Installation
Operation
TRANSPORTATION AND PLACEMENT
•
When transporting the chest freezer from one place to another, the inclination of the cabinet should not
exceed 45 degrees, for prevention against compressor or system damage.
•
Before use, remove all the packing material. The back side of the cabinet should be more than 20cm /
7.87” away from the wall, both flank sides more than 20cm / 7.87”.
•
The freezer should be put in well-ventilated, dry place. Don’t use it under direct sunshine. The freezer
should be kept away from water sink, heat source and any volatile, corrosive material.
POWER SOURCE AND TEST-RUNNING
• Specified capacity of the wire is 6A. Section squares of the wire is 0.75mm. Single line or compound lines
are all allowed. The fuse of 2.5A specified electric current should be installed. (Power cord should be
replaced with the same of 6A and 0.75mm, when it is damaged).
• Single-phase power supply, 60Hz, voltage 110-120V. If the voltage is unstable, please install a voltage
stabilizer with capacity above 1000W.
• Avoid turning on and off the power too frequently. If the power is turned off, wait an interval of 5 minutes
before turning it on again.
• When the freezer will be out of use for a long time, disconnect the power first, then clean it. Please
examine the circuit whether it is excellent before reuse.
ADJUSTING OF THE TEMPERATURE
•
The temperature in the cabinet can be controlled with the temperature control screw and can be adjusted
using a flat head screwdriver.
•
FREEZING MAX is the strongest cooling position and is suitable for fast freezing. Do not keep the screw at
this point for long.
FOOD STORAGE
•
There must be space between the foods stored in the cabinet, between the foods and the inner surface
of the cabinet, so as to keep good ventilation of cold air and freeze evenly. Do not put in any bottled or
canned beverage with freezing point above the temperature in the cabinet when it is below zero.
•
For foods that should be moisture-free or lose water easily, wrap them up with hermetic food bags or fresh
films before putting in the cabinet for the sake of avoiding smell-mixing and reducing frosting.
• Storage of volatile and combustible gases, liquids such as strong alkalies, strong acids, petrol, etc. is
forbidden.
Содержание FR-CN-0005
