7
Troubleshooting
Problem
Cause
Solutions
Lights are off while turned on.
The power cord is not properly
plugged into the outlet or the
machine.
Turn off all switches and make
sure the power cord is firmly
plugged into the outlet and
machine. Turn on the switch again.
The motor does not rotate/heat
when the TURN switch is on.
The heating tube line is loose/
burnt.
Tighten the line/change the heating
tube.
The heating temperature is too
high or too low.
The constant temperature element
is out of order.
Change the element.
Operation
2. Turn on the kettle switch to preheat the kettle for 5 to 6 minutes. Pour 50ml of oil, 150g of corn and 50g of
sugar into the kettle, the corn will burst open.
3. Pay attention to the corn while popping in case it will be burnt. Close the door firmly so that the corn can
not flow out. Stir the corn until it is all burst open, then twist the handle clockwise, lift the elastic cover to the
top. Keep the kettle hung upright and pour all the popcorn out from the plate.
4. Repeat steps 1 - 3 to make more popcorn. It will only take 2 minutes to pop the corn in a continuous
fashion.
Take care when pouring the oil to prevent scalding. Do not drop any oil around the plate. Otherwise it
will catch fire when it is heated to a certain temperature. Keep the kettle clean.
This machine has over-temperature protection when the temperature rises over the normal line, it will
cut off the electricity to protect the machine and the user.
Maintenance
1. Clean your popcorn machine after every use.
2. Make sure the machine is unplugged and the kettle has completely cooled.
3. Wipe all oils off the inside and outside of the kettle with a DRY clean soft cloth.
4. Do not use benzene, scrubbing brushes or chemical cleaners, as these will damage the machine.
5. NEVER immerse the base of machine in water or let water drip inside.
