8
Operation
WARNING
Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer.
WARNING
Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound
from the tank.
OVER-TEMPERATURE SHUTDOWN
If the shortening becomes overheated, a high-temperature shutoff device will turn the gas valve off and
extinguish the pilot. If the fryer shuts down due to overheating, DO NOT re-light the pilot until the shortening
temperature is below 149°C (300°F). If an overheating situation persists, contact qualified technician for help.
BEFORE FIRST USE
CLEANING
New units are wiped down at the factory to remove any visible signs of dirt, oil, grease, etc. remaining from the
manufacturing process. Before any food preparation, thoroughly wipe protective oil from all surface parts and
the tank interior with hot soapy water to remove any film residue and dust or debris.
Notice: do not use chlorine or sulfate/sulfide cleaners.
•
Wash any accessories shipped with unit.
•
Rinse fryer and accessories thoroughly and drain the fryer.
•
Wipe tank completely dry with a soft, clean cloth.
FILLING TANK WITH SHORTENING
Solid shortening should NOT be used with this type of fryer. Melting solid shortening will damage the tank.
•
Close the drain valve.
• Fill the fryer tank with liquid shortening.
•
Shortening level should be between the min and max lines in the fryer tank.
•
Shortening will expand when heated. Do not ill the fryer tank past the MAX line.
•
Add fresh shortening as needed to maintain oil level.
LIGHTING THE PILOT
1. Open the door.
2.
Turn the thermostat OFF (see figure below, view A). The thermostat is located behind the door.
3.
Push the gas control valve knob and turn to OFF. Wait 5 minutes for unburned gas to vent.
4.
Push and turn gas control valve knob to the “L” in PILOT (see figure below, view B).
5.
While still holding the knob in, light the pilot with a lit flame. Continue to depress the knob until pilot remains
lit when knob is released. If the pilot does not remain lit, repeat step 3 through 5.
6.
Depress and turn gas control knob to ON (See figure below, view C).
Содержание CE-CN-0025-CTN
Страница 13: ...13 Parts Breakdown Model CE CN 0025 CTN 47749 ...
