Omcan 48387, Инструкция по эксплуатации, Страница: 9 / 16

9
Maintenance
5. With the conveyor turned on and the crumb tray in place, take a wire grill brush or dry abrasive pad, clean
the exposed surface of conveyor belt by passing the brush or pad, back and forth across the surface of the
conveyor belt as the belt moves past. Continue until the entire belt is clean. Make sure the crumb tray is
installed, this will minimize the amount of particles that fall into the oven.
6. When the conveyor belt is clean, take a damp cloth and wipe the conveyor, removing any loose particles
on the belt surface.
7. Remove the crumb tray by sliding it out from beneath the conveyor belt. Clean the crumb tray by wiping
with a damp cloth and mild detergent.
• Do not use corrosive cleaners.
• Do not run conveyor oven without crumb trays installed.
• Overheating to electrical components and premature failure can occur.
• Do not immerse or let the unit stand in water.
• Do not hose down the unit or the table/counter if the unit is on the table/counter.
• Keep away from running water.
MONTHLY
REMOVAL AND CLEANING OF CONVEYOR BELT
1. Turn main power switch to the OFF position. Disconnect unit from its power source and allow to cool.
2. Perform daily and weekly cleaning procedures. To remove links, unhook each end of one link and bring the
two ends together, and un-thread. Once detached, re-hook onto itself so not to get damaged.
3. Now that the links have been unhooked, the conveyor can now be carefully removed from the oven.
Standing at one end of the oven. Starting with the end on the bottom, roll the conveyor belt until it has been
totally removed. Take careful notice being sure not to damage the heater tubes, and working it over the
drive sprockets.
4. Clean conveyor belt in deep sink, caustic cleaners may be used. For a heavy soiled conveyor belt, soak
over night in hot soapy water.
NOTE: Do not attempt to clean the heater tubes.
5. Take this opportunity to clean and remove any loose materials inside the unit. Using a mild cleaner and
damp cloth, carefully wipe the inside surfaces being sure NOT to clean the heater tubes. DAMAGE
CAN OCCUR TO THE HEATER TUBES FROM IMPROPER CLEANING. DO NOT SPRAY CLEANING
SOLUTIONS INTO OVEN CAVITY.
6. Reinstall conveyor belt by first laying the belt along the bottom of the oven cavity making sure the hooks on
the sides are facing the inside and ends of the hooks will be pointing away from the direction of the belt so
not to catch on any internal components once put back into operating. Also, being sure to properly align the
belt over the conveyor drive sprockets.
NOTE: The direction of the belt.
7. Next, pull one end of the conveyor belt over the top of the sprockets, (being sure to line the links up
properly with the sprockets) bring the two ends together.