7
Installation
Operation
Maintenance
heat sources.
•
Position the device in such a way that the plug is easily accessible.
• Before first use, clean the inner sides and the shelving grids with a soft cloth and a mild cleaning agent.
Afterwards, dry the device thoroughly.
• Remove the water bowl from the device. The water bowl is installed inside the device and then fill the water
bowl with water.
•
Connect the device to a single grounded power socket.
• Set the temperature as required for respective foods. You may adjust the desired temperature in the range
between 30 - 90°C / 86 - 194°F.
•
The temperature inside of the hot display can be read from the front display.
•
Put the foods in appropriate containers before placing them inside the hot display.
•
Some of the device parts become very hot, always use safety gloves when placing or removing foods.
•
The food is kept warm at the temperature set by you previously.
•
In order to place or remove foods. You may open the door on the rear side.
• Switch on the inner light when required using the light switch of the device.
•
Disconnect the device from the power socket when the device is not in use.
•
Before beginning with repairs or cleaning, make sure the device has been disconnected from the power
socket and has cooled down.
•
Don’t use any acidic agents and make sure no water enters the device.
•
To protected yourself from electric shock, never immerse the device, its cables and the plug in water or
other liquids.
•
Don’t use any kind of pressure water jet for cleaning the device.
CLEANING
•
The device should be cleaned regularly.
•
Clean the device from the inside and outside with a soft, damp cloth and a mild cleaning agent.
•
Clean the placing grids and the housing with a soft, damp cloth and a mild cleaning agent.
• Clean the water bowl regularly. Calcification at the water bowl may be removed with common agents or
liquids.
•
Only use a soft cloth and make sure you never use any kind of abrasive agents or pads which could
scratch the surface.
•
After the cleaning procedure, you should use a soft and dry cloth to wipe dry and polish the surface.
•
Make sure the device has been cleaned properly before storing it in a dry place.
Содержание 47477
Страница 9: ...9 Model DW CN 0097 SF 47477 Parts Breakdown ...
Страница 10: ...10 Model DW CN 0097 SF 47477 Parts Breakdown ...
Страница 12: ...12 Model DW CN 0097 SF 47477 Electrical Schematics ...
