Omcan 46492, Инструкция по эксплуатации, Страница: 8 / 20

8
Maintenance
Operation
• The freezer should be cleaned regularly. When cleaning, turn off the power, take out the food in the cabinet,
clean the inside using water or a little neutral detergent.
• Do not use boiling water, acid, chemical diluents, petrol and oil, or dirt-removing powder.
• Dry it after cleaning.
• Use light soap water when cleaning the door seal, apply a little of talcum powder on it after natural drying to
extend its service life.
• Use soft cloth with water or a little detergent to clean the out surface. Note, keeping the power supply and
lower part of connect wires away from water to avoid electricity leakage.
• Except common breakdowns, those who are not service technician should not take apart and repair the
freezer on their own so as to avoid worsening the trouble. Unauthorized repair of electrical part such as
compressor, temperature controller is forbidden.
DEFROSTING
• Defrost for better freezing efficiency when the frost film in the cabinet is 4-5mm thick.
• When defrosting, turn off the power, take out the frozen foods, open the door for warming and melting. Use
a soft cloth to absorb water and clean it up.
• Do not use sharp metal tools such as steel brush to clean the frost film when defrosting so as to avoid
evaporator damage.
beverage with freezing point above the temperature in the cabinet when it is below zero.
• For foods that should be moisture-free or lose water easily, wrap them up with hermetical food bags or
fresh films before putting in the cabinet for the sake of avoiding smell-mixing and reducing frosting.
• Storage of volatile and combustible gases, liquids such as strong alkalies, strong acids, petrol ,etc. is
forbidden.
• Never put hot food directly in the freezer. Food should be cold or frozen before placing it inside.
• The cabinet is intended exclusively for the storage and/or display of packaged foods only.
Troubleshooting
Problem Possible Cause Solution
The indicator is not on.
The compressor does not start.
The plug isn’t fully connected to
the socket.
Replug it.
No power. Connect the socket with power.
The indicator is on, but the
compressor doesn’t work and
buzzes only.
The power voltage is <98V. Put a power-regulater more than
1000W power together.