9
Operation
Maintenance
AFTER USE:
follow the instructions described in the Maintenance section.
CLEANING AND MAINTENANCE BEFORE USE
• Cleaning is the only maintenance operation usually required.
• TURN THE MASTER SWITCH TO POSITION “0” AND REMOVE THE PLUG FROM THE SOCKET.
•
Clean the machine carefully with a dry cloth or with a soft brush.
• AFTER FITTING AND TURNING ON THE MOTOR. It is possible to complete the cleaning operations by
passing a piece of dough through the rollers (to remove any dust). The same operation can be carried out
for the cleaning of the Simplex Roll and Cut Accessory. The dough used for this operation must obviously
be thrown away.
• NEVER wash the machine body with running water or detersive.
•
Do not put any part of the machine in the dishwasher.
CLEANING AND MAINTENANCE AFTER USE
• TURN THE MASTER SWITCH TO POSITION “0”.
• MACHINE BODY. Clean the accessory using a dry cloth or a soft brush.
• OTHER PARTS OF THE MACHINE The other parts of the machine (pasta hopper, roll and cut accessory)
arm can be cleaned with a damp cloth.
• Never remove pasta residues using sharp utensils.
• NEVER wash the body of the machine with running water or detersives.
• Do not wash any part of the machine in the dishwasher. Ensure that the parts are perfectly dry before
putting them away after use.
Troubleshooting
PROBLEM
PROBABLE CAUSE
SOLUTION
If the machine won’t start or stops
suddenly.
The machine is not plugged in or
the plug is not fully inserted into
the socket.
Plug in the machine correctly.
The master switch is in position
“0”.
Place the master switch in position
“I”.
The metal roller is raised.
Lower the metal roller exerting
slight pressure on the dough.
If the above solutions do not resolve the problem, contact Omcan.