Omcan 41419, Инструкция по эксплуатации

Страница: 9 / 16

9
Maintenance
CLEANING THE GRINDER
• Parts which are subject to wear mainly include the cutting elements, in this case the blade and the
perforated plate.
• The condition of these components should be checked regularly, and sharpening of the same, if necessary,
should be done by competent personnel. These parts must be replaced when it is necessary.
• Every now and then check the conditions of bush placed between the screw and the body. In case of
abnormal wear, it should also be replaced to avoid possible damage to other parts of the machine.
• It is advisable to use original spare parts made by the manufacturing company to avoid any inconvenience
due to different manufacturing characteristics.
• In the order of spare parts, the model, the series number indicated on the label of motor group (and on the
conformity declaration), and the reference letter of the part must be specified.
• For models with gears operating in oil bath, follow these notes carefully:
• The oil supplied is MOBILGEAR 636 (Viscosity cSt 40° C 636; Viscosity cSt 100° C 37,1 ISO 680).
• A change every 300 working hours with the same oil or with similar (of the same viscosity) oils for
reduction units is recommended.
Models with MT 1:
• For the topping-up, put the power unit in vertical position, unscrew the oil plug placed in the front part of
the reduction unit, pour the a.m. oil up to cover the oil window positioned in the same oil plug. Then,
retighten the plug and place again the power unit in horizontal position.
• For the oil changing, unscrew as the oil plug, and allow the output of the oil to be changed from the
motor reducing group: a good dripping must be attained.
• Pour the new oil in quantity of about 125 cm
3
and retighten the plug.
Models with MT 4:
• For the topping-up, unscrew the oil plug placed in the upper part of the reduction unit, pour the a.m. oil up
to cover the oil window positioned in the lower part of the reduction unit. Then retighten the upper plug.
• For the oil changing, unscrew as the upper oil plug as the oil window in the lower part of the reduction unit,
so allowing the output of the oil to be changed: a good dripping must be attained.
• Retighten the level window. Pour the new oil in quantity of about 125 cm
3
and retighten the upper plug.
It is recommended to execute the topping-up or changing operations in proper environment, with the motor
assembly disassembled from the grinding unit, with the switch settled in the stop position (0) and with the plug
disconnected from the socket of the main supply.
Remember that the disposal of the exhaust oil must follow the rules in force (not scattered to the environment).
REFERENCE
Item Number Model Number Description
Manufacturer Model
Number
41419
MG-IT-0012
Meat Grinder #12 Cast Iron 100 RPM
0.6 HP / 440 W 110V/60/1 cCSAus
19100E/CSA