Omcan 31438, Инструкция по эксплуатации

Страница: 7 / 24

7
Operation
Maintenance
off and rotate the slice thickness control on zero.
BLADE SHARPENING
Whenever the cut is not satisfactory, sharp the blade. The time interval between a sharpening and the following
depends on the intensity of use of the slicer and on the kind of food you cut. Replace the blade when the
diameter becomes 10 mm less than the nominal diameter. For the replacement, ask the assistant service
closest to you.
WARNING
The replacement of the blade is dangerous operation. Should the sharpening quality be not satisfactory,
replace the stones. Contact a customer servicing.
1. Clean the blade removing any greasy residue.
2. Make sure that the machine is off.
3. Rotate the slice thickness control to zero to make sure that the blade is covered by the slice thickness
plate.
4. Lift the sharpener cover.
5. Slip off completely the sharpener and spin it 180 degrees.
6. Put the sharpener device.
7. Push the green button to start the machine.
8. Sharpening: Press the sharpening wheel for about 10-15 seconds. Then press simultaneously also the
grinding stone for two seconds. Contemporaneously loosen the two grind stones. The sharpening and
honing take place then simultaneously.
WARNING: for a suitable effect please execute sharpening for 10-15” approx.
9. Press the red stop pushbutton.
10. Lift and rotate 180 degrees the sharpener and reallocate it into its initial position. Loosen the handle
rotating it clockwise to block the sharpener. Lower the sharpener cover.
SHARPENER DEVICE REMOVAL
To facilitate the cleaning of the sharpening grinder, remove the sharpener device pulling it upwards.
WARNING: Do not immerse in water or detergent the sharpening device.
CLEANING OF THE GRINDING WHEELS
To obtain an excellent sharpening the grinding wheel must always be clean. Remove dirt and grease with
alcohol and the supplied special brush.