Omcan 0920-HC, Инструкция по эксплуатации, Страница: 14 / 48

14
Controller Instructions
Table of Functions activated by the buttons - Models s, X, Y, C (Table 2)
Button Normal Operation Start Up
Pressing the Button Alone Pressed Together
Up
ON/OFF
More than 3 sec: toggle ON/
OFF
Start/Stop
continuous cycle
-
Down
Defrost
More than 3 sec: start/stop
defrost
Pressed
together
Start parameter
reset procedure
For 1 sec.
display
firmware
vers. code
Set Mute - 1 sec.: display/set the set
point.
- more than 3 secs.: access
parameter setting menu
(enter password )
- mute audible alarm
(buzzer)
- For 1 sec.
RESET cur-
rent EZY set
setting the set point (desired temperature)
• press
SET
for 1 sec, the set value will start flashing after a few moments.
• increase or decrease the value using UP or DOWN .
• press SET to confirm the new value.
switching the device ON/OFF
Press UP for more than 3 sec. The control and defrost algorithms are now disabled and the Instrument
displays the message “OFF” alternating with the temperature read by the set probe.
Manual defrost
Press for
DOWN
more than 3 sec (the defrost starts only the temperature conditions are valid).
Continuous cycle
Press UP and DOWN together for more than 3 sec.
Access and setting type F (frequent) and type C (configuration) parameters
1. press SET for 3 sec (the display will show “PS”).
2. • to access the type F and C parameter menu, enter the password “22” using UP/DOWN , press SET to
confirm.
• to access the F parameter menu only, press
SET
(without entering the password).
3. scroll inside the parameter menu using UP/DOWN .