4/4
DEFINITIONS
Motors
electrical
data
1~
S1
33
W
V
Hz Phase N° Service
A
IP
Degree of
Protection
240
50
120
60
7
REMARK: Stop the carriage at the
end of the stroke nearest the
oprator and pour the lubricant into
the special oiler
Carriage bar oiler
Slice thickness control knob
Product holder fixing knob
Carriage release handle
Product holder stroke
adjustement
Start Product holder
Stop Product holder
Stop Balde
Start Balde
NB: For the manual funtioning of the carriage
rotate the handle clockwise by 180°
Power Supply (led)
Start Balde (led)
Start Product holder (led)
550
B
D
620
580
430
TECHNICAL DATA
C
A
CX Matic
Slicing Capacity mm
Ø 300
Ø 330
Ø 350
Ø 370
A
150
165
185
190
B
260
260
260
260
C
250
270
290
305
D
210
235
240
260
MANUAL OPERATION
Rotate the AUTO/MANUAL selector carriage release handle by 180
0
,clockwise
Push the on switch/blade start pushbutton
Adjust the thickness you want by turning the slice thickness control knob
Actuate the carriage by your hand
Push the off switch/blade stop pushbutton
AUTOMATIC OPERATION
Rotate the AUTO/MANUAL selector carriage release handle by 180
0
, counterclockwise
Push the on switch/blade start pushbutton
Adjust the thickness you want by turning the slice thickness control knob
Push the product holder start pushbutton
Adjust the length of the stroke by turning the product holder stroke adjustment
Push the product holder stop pushbutton to end carriage movement
Push the off switch bIade stop pushbutton
LUBRICATION
The rod on which the product holder slides, which is underneath the slicer, should be lubricated
weekly with several drops of oil. Stop the carriage at the end of the stroke nearest the operator position
and pour the Iubricant into the special oiler. DO NOT use vegetable oil. Occasionally, the slice thickness
plate slide rod should be coated Iightly with lubricant. Turn the slice thickness control fully counterclockwise
when Iubricating this slide rod and then turn it fully clockwise when finished. DO NOT lubricate the rod on
which the last slice device slides. It must be kept clean but not lubricated. The motor has sealed
bearings and requires no Iubrication maintenance.
WEAR ADJUSTMENT
After several, years of operation and many sharpenings of the blade it may become necessary to have
the slice thickness plate 14 adjusted closer to the blade.
