Olympus SZH-STAD1, Инструкция по эксплуатации

Страница: 22 / 34

SZX
18
TROUBLESHOOTING GUIDE
Under certain conditions, performance of this unit may be adversely affected by factors other than defects. If a problem
occurs, please review the following list and take remedial action as needed. If you cannot solve the problem after checking
the entire list, please contact your local Olympus representative for assistance.
Problem Cause Remedy Page
11
11
5
4
13
ii
ii
9,20
4
ii
11
11
8
8
1. Incomplete binocular vision.
Interpupillary distance is not correctly ad-
justed.
Diopter adjustment is incomplete.
Left and right eyepieces are not matched.
Adjust it correctly.
Complete diopter adjustment.
Use a pair of matched eyepieces.
2. Field of view is cut off or illu-
minated unevenly.
Aperture iris diaphragm is stopped down
excessively.
Observation tube and intermediate at-
tachment are not correctly mounted.
Light path selector knob is stopped mid-
way. (SZX-TR30)
Open the aperture.
Mount them correctly.
Set correctly to the desired position.
3. Dust is visible in the field of
view.
Dust on the specimen.
Dust on eyepiece.
Remove dust.
Remove dust.
4. Excessive image contrast. Aperture is stopped down excessively
(when the built-in aperture iris diaphragm
and SZX-AS are used).
Open the aperture to proper diameter.
5. Resolution problems:
· Image is not sharp.
· Insufficient contrast.
Objective is not correctly mounted.
Dust on objective front lens.
Dust on top or lower lens of zoom micro-
scope body.
Dust on upper or lower lens of zoom ob-
servation tube.
Mount it correctly until it is stopped.
Clean lens surface.
6. Specimen image blurs
when zoom magnification is
changed.
Diopter ring is not correctly adjusted.
Not in complete focus on specimen.
Adjust it correctly.
Focus specimen correctly at a high mag-
nification.
7. Coarse focus adjustment
knobs rotate with too much
resistance.
Tension adjustment ring is too tight.
Loosen it properly.
8. Zoom microscope body
drops or specimen goes out
of focus during observation.
Tension adjustment ring is too loose.
Tighten it properly.
9