6
7
Battery is OK. You can shoot.
Battery is low and will need
to replace within the next few
photos.
Battery is dead and must be
replaced with a new one
immediately.
lights (turns off
automatically).
blinks and other
indicators are displayed
normally.
blinks and other
indicators go out.
1
2
3
1
2
USING THE STRAP
Attach the strap as shown.
LOADING AND CHECKING THE BATTERY
Use one 3 V lithium battery (CR2).
1. Slide the back cover release upward
to open the back cover.
Do not touch the inside of the
camera, especially the lens.
2. Insert the film cartridge until it
clicks into position.
ISO400 film is recommended. If you
are going to use non-DX-coded film,
use ISO100 film.
LOADING THE FILM
3. Position the end of the film leader
ahead of the line pointed to with the
arrow (
A
), and align the edge of the
perforated section (
B
) with (
C
).
Make sure that the film is
positioned correctly between the
positioning guides (
D
). Then close
the back cover until it clicks. Make
sure the back cover release has
returned to the lower position.
The film automatically advances to
the first frame.
Correct
Incorrect
4. Open the lens barrier until it clicks.
Make sure the exposure counter on
the LCD panel reads “ ”.
If “ ” blinks, reload the film.
3
1. While pressing the bottom of the
battery compartment cover
1
, lift
it as indicated to open
2
.
Make sure the lens barrier is closed
before opening the battery
compartment cover.
2. Insert the battery correctly
1
.
Close the battery compartment
cover
2
.
A new battery lasts for about 10 rolls
of film.
3. Slide the lens barrier as indicated
1
until it clicks. Check the battery
power as noted on the LCD panel.
4
