E-14
Removing the TTL cable connector cap
To perform TTL flash shooting in
combination with the separately
available Electronic Flash Case,
remove the TTL cable connector
cap as described below.
1
Remove the TTL cable connector
cap from the Case.
2
Connect the Electronic Flash
Case’s underwater TTL cable to
the TTL connector on the Case.
②
Remove.
①
Turn counter clockwise.
TTL cable
connector cap
③
Insert into the
connector.
Underwater
TTL cable
Use this mark to
align the position.
④
Turn the threaded section of the connector
clockwise lightly until it is stopped.
1
2
---- How to attach the TTL cable connector cap to the case ----
Make sure there is no foreign matter attached to the O-rings inside the cap and on
the TTL cable connector. To secure the cap, gently turn it clockwise until it stops.
Cap
Connector
Check O-rings
①
Put the cap
on the case.
②
Gently turn the cap
clockwise until it stops.
: • If the TTL cable connector cap is loose, water
penetration may result. Be sure to gently turn the cap
until it stops to make sure it is firmly secured.
Do not turn or tighten the TTL cable too hard. If it is too
tight, it may be difficult to loosen and remove it.
CAUTION
❈
For details on the TTL cable and hot shoe cable, refer to the
instruction manual provided with the Electronic Flash Case.
PT̲030̲EN.qxd 05.10.28 6:33 PM ページE-14
