Olympus PT-E06, Инструкция по эксплуатации

Страница: 41 / 200

EN 12
En
When using the TTL cable
When connecting the optional electronic flash with the underwater TTL cable (optional: PTCB-E01),
connect the hot shoe cable (optional: PHCB-01) to the camera and front cover of the Case.
How to connect the hot shoe cable
1
Turn the hot shoe cable connector cap inside the Case counter-clockwise to remove it.
2
Insert the connector of the hot shoe cable into the Case's connector and turn the connector screws
all the way clockwise to connect them firmly.
3
Load the camera in the Case, and then connect the hot shoe cable to the camera.
Connecting the underwater TTL cable
1
Turn the TTL connector cap of the Case counter-
clockwise and remove it.
2
Connect the underwater TTL cable (optional:
PTCB-E01) to the TTL connector on the Case.
3
When not using the underwater TTL cable,
attach the TTL connector cap.
Make sure there is no foreign matter attached to the
O-rings inside the cap and on the TTL cable
connector. After that, gently turn it clockwise until it
stops.
CAUTION:
If the TTL connector cap is loose, water leakage may result.
Underwater
TTL cable
Insert into the
connector.
Use this mark to
align the position.
Turn the threaded
section of the
connector clockwise
gently until it stops.
Check O-rings
Cap Connector
PT-E06_EN.Book Page 12 Thursday, February 26, 2009 5:04 PM