EN 4
En
Handling the Product
z
Use or storage of the product at the following locations may cause defective operation, defects,
damage, fire, internal clouding, or water leakage. This should be avoided.
• Places of high temperatures, such as in direct sunlight, in a closed vehicle, etc., and/or where
extreme differences in temperatures exist.
• Places with open fire
• Water depths in excess of 40 m
• Places with vibrations
• Places with high temperature and humidity or with severe temperature changes
• Places with volatile substances
z
This product is made of polycarbonate resin with excellent impact resistance, but it may be damaged
by rubbing against rocks etc. It also may break when it is hit by hard objects or is dropped.
z
This product is not a case to soften impacts to the camera inside the product. When this product with
a digital camera inside is subjected to impact or heavy objects are placed onto it, the digital camera
may become damaged. Please handle it with sufficient care.
z
When the product is not used for a long time, the waterproof performance may drop because of
deterioration of the O-ring etc. Before use, always perform the advance test and the final check.
z
Be careful not to apply excessive force to the port connector, TTL cable connector, zoom dial or tripod
seat.
z
Do not push the air vent valve from inside.
z
Do not use the following chemicals for cleaning, corrosion prevention, prevention of fogging, repair or
other purposes. When these are used for the Case directly or indirectly (with the chemicals in
vaporized state), they may cause cracking under high pressure or other problems.
z
Do not perform operations other than specified in this instruction manual, do not remove or modify
parts other than specified, and do not use parts other than specified.
Any trouble in taking pictures or with the equipment resulting from the above actions shall not be
covered by the guarantee.
z
OLYMPUS IMAGING CORP. shall in no way be responsible for accidents involving immersion of a
digital camera in water.
z
OLYMPUS IMAGING CORP. shall not pay any compensation for accidents (injuries or material
damage) at the time of use.
Chemicals which cannot be
used
Explanation
Volatile organic solvents,
chemical detergents
Do not clean the Case with alcohol, gasoline, thinner or other volatile
organic solvents or with chemical detergents etc. Pure water or
lukewarm water is sufficient for cleaning.
Anticorrosion agent
Do not use anticorrosion agents. Pure water is sufficient when washing
the metal parts as stainless steel and brass are used.
Commercial defogging
agents
Do not use commercial defogging agents. Always use the specified
desiccant silica gel.
Grease other than specified
silicone grease
Use only the specified silicone grease for the silicon O-ring, as
otherwise the O-ring surface may deteriorate and water leakage may
occur.
Adhesive
Do not use adhesive for repairs or other purposes. When repair is
required, please contact a dealer or a service station of OLYMPUS
IMAGING CORP.
PT-E05_EN.Book Page 4 Wednesday, June 4, 2008 12:34 PM
