Olympus PT-018, Инструкция по эксплуатации

Страница: 14 / 38

E-13
Setting the Zoom Lever
When loading the digital
camera in the Case, fit the
projecting part of the zoom
lever of the digital camera into
the recessed part of the zoom
lever on the inside of the Case.
Note：・When the set time (initial setting: 3 minutes) passes without any
operation while the digital camera is installed in shooting mode, the
camera enters into sleep mode (standby status) and the operation
stops.
To cancel sleep mode (return to operation status), press the
shutter button or any other button.
For details, refer to the instruction manual for the digital camera.
Power Switch Operation Method
Press the power button to switch on the camera power supply.
When the power switch is pressed again, the camera power supply is
switched off.
Note：・For details about using the flash for taking pictures, refer to the
instruction manual for the camera.
Flash Operation Method
When the flash lever is operated, the camera flash pops up. When the
flash close lever is operated, the flash stored in the camera.
:: • When loading the camera, confirm that the projecting part of
the zoom lever of the camera is properly set to the recessed
part of the zoom lever of the Case.
•
When the setting is insufficient, the loading of the camera
becomes imperfect and it may not be possible to seal the
Case or zooming may not function. Insufficient sealing will
cause water leakage.
CAUTION