E-2
PPO-E05 main body
Silicon O-ring (POL-E101)
Front cap
Rear cap
Zoom gear (PPZR-E06)
Grease for silicone O-ring
O-ring remover
1
Name of Parts
2
Mounting the PPO-E05 on the Waterproof Case
Port mount thread
O-ring contact surfaces
O-ring
Threaded
section
Grease applying surface on O-rings
This section describes how to mount this
product on the PT-E series case. Before
mounting, check that no foreign matter is
attached to the O-rings, the port mount
thread on the PT-E series case, or the O-
ring contact surfaces. Apply a thin layer of
the provided silicone O-ring grease.
Align the threaded section of the PPO-E05 with the port mount thread on the PT-E series case.
Hold the PT-E series case firmly with one hand, hold the main body of the PPO-E05 with your other
hand and screw it into the PT-E series by turning the PPO-E05 clockwise.
Resistance increases as the PPO- E05 is screwed in more deeply. However, be sure to screw it in all the
way until there is no gap visible below the threaded section of the PPO-E05.
Screw in until
there is no gap.
PPO-E05̲En 06.10.24 4:39 PM ページ2
