Olympus Panametrics Epoch 4 Plus, Руководство пользователя

Страница: 88 / 188

78
EPOCH 4PLUS
5. Press [F2] for Recall when the appropriate ID is listed at the top of the screen (see Step
4 above for details). The calibration is recalled, and the EPOCH 4PLUS is in the
Freeze mode. You cannot change any parameters while in Freeze mode.
6. Press [FREEZE] to go to the live screen. The EPOCH 4PLUS is ready for use with the
same parameter settings used when this calibration was initially saved.
8.8 Saving and Recalling Quick Recall Calibrations
The EPOCH 4PLUS has a total of nine dedicated “quick recall” transducer calibration
slots. These are located in files 1-9 of the datalogger and are denoted by an asterisk (
*)
next to the file number. These files can only store one calibration (with complete setup
parameters and waveform) in each file. They are designed to store the most frequently
used calibration setups and can be recalled using two key presses.
To save Quick Recall Calibrations, follow these steps:
1. Enter the Memory screen and create a file name for the desired quick recall file (file
locations 1-9). See Creating Files and Identifier (ID) Codes on page 4. After entry of
the file name, exit the Memory screen with the cursor over the desired file.
2. Enter an ID code. See Creating Files and Identifier (ID) Codes on page 4.
3. Press [SAVE WAVE].
Note: A memo can be entered before or after the calibration is actually saved in
order to provide more detail about the type of calibration.
Thickness readings cannot be saved in Calibration Files 1-9. “ERROR” will
appear if [SAVE THICK] is pressed when attempting to do so.
Only one waveform/calibration setup can be saved in Calibration Files 1-9.
“ERROR” appears if [SAVE WAVE] is pressed a second time when saving
to a file 1-9.
To perform a Quick Recall Calibration, follow these steps:
1. Press [CALIBRATION] from the live screen. The Cal symbol appears on the screen.
2. Press the desired key [1], [2], ...[9] associated with the desired calibration to recall. A
pop-up box appears on the screen to confirm.
3. Press [F1] to recall the calibration or [F2] to abort.
8.9 Creating Memos
Use the MEMO feature to enter descriptive comments to include with stored data. This is
used to supplement the single note (10 character maximum) that can be added to each file.
Memos are usually used to provide further details about a measurement condition or
calibration. Memos can only be entered from the live screen.