Olympus OmniScan SX, Руководство пользователя

Страница: 56 / 86

DMTA-20043-01EN [U8778624], Rev. B, May 2013
48 Chapter 4
4. Make sure that the battery compartment door is closed correctly.
5. To restore the instrument’s original finish, clean the casing with a soft cloth.
6. To remove persistent stains, use a damp cloth with a mild, soapy solution. Do not
use abrasive products or powerful solvents, which could damage the finish.
7. Once the connector protectors are removed, make sure the connectors are dry
before connecting anything to them. If they are wet, dry them with a soft, dry
cloth, or let them air dry.
4.2.2 Screen and Screen Protector Cleaning
Never use abrasive products or powerful solvents to clean the OmniScan SX touch
screen and screen protector. Clean the touch screen and screen protector using a
damp cloth moistened with a standard, evaporating glass cleaner. If necessary,
remove any paper-towel residue with a soft-bristle brush.
4.3 Replacing the Touch-Screen Protector
This section explains how to replace the touch-screen protector.
To replace the touch-screen protector
1. Remove any dust or dirt on the touch screen (dust and dirt cause bubbles to
appear on the protective film). See section 4.2.2 on page 48.
2. Simply remove the label marked No. 1, and peel away the protective film on the
back.
Avoid touching the back of the screen protector after the protective film on the back is
peeled away. Doing so will leave a trace of your finger prints.
3. Align the protector into the correct position on the screen, and slowly install the
screen protector.
4. Remove the label marked No. 2, and peel away the film on the front. Provided
that there is no dust trapped underneath, all small bubbles will dissipate within
48 hours.