DMTA-10040-01EN, Rev. E, February 2018
Using the Instrument
285
5.
Press the FREEZE key (
) to enable signal acquisition.
6.
Press the DISP menu key (
), followed by
DSP MODE
(display mode, A key),
and then rotate the knob until
SWP + IMP
(sweep plus impedance) is displayed
(see Figure 5-230 on page 285).
Figure 5
‑
230 The SWP + IMP display
7.
Press
SWP TIME
(D key) and adjust the sweep time to accommodate the length
of the tube being inspected.
8.
Place the probe in a defect-free area of the calibration standard near the thru-wall
hole, and then press the NULL foot switch.
9.
Slowly scan the tube.
The scan result should be similar to that shown in Figure 5-231 on page 286. The
SWP
(sweep) display on the left of the screen clearly shows the larger indications
(full screen) that represent the 40 % and 60 % wall-loss flaws. The center (smaller)
indication represents the thru-wall hole.
Содержание nortec 600
