Olympus HST-Lite, Руководство пользователя

Страница: 20 / 44

DMTA-20045-01EN, Rev. A, October 2012
16 Chapter 1
1.4 Positioning the Wheel Encoder
To position the wheel encoder
1. Loosen the wheel encoder thumbscrew (see Figure 1-10 on page 16).
2. Slide the wheel encoder to the desired position (see Figure 1-10 on page 16).
3. Tighten the wheel encoder thumbscrew.
Figure 1-10 Positioning the wheel encoder
1.5 Installing Tubing and Cables
To install tubing and cables
1. If you plan to use the offset probe configuration, assemble the HST-Lite Scanner
according to section 1.9 on page 26.
2. If required, install the preamplifier (see section 1.8 on page 24).
3. Connect the probe cables to the probes.
4. Cut four pieces of transparent tube. They should measure about 3.8 cm (1.5 in.)
long.
5. Install the four transparent tubes on the wedges (see Figure 1-11 on page 17).
6. Install a Y-fitting on each pair of transparent tubes (see Figure 1-11 on page 17).
Wheel encoder thumbscrew
Slide the encoder