Suppresses low-level signals in received signals and
adjusts the level of processing used to reduce noise.
Press the LE REDUCTION [+] or [–] key to adjust the
processing level.
Adjusting the LE Reduction
Freeze the ultrasound image
and press the CINE REVIEW
key to switch to the image to
be displayed.
Press the brightness adjustment buttons ([+] and [–]
buttons) to adjust the brightness for the target distance.
* The STC can also be adjusted by tapping the brightness adjustment bar.
Adjusting the STC
Using CINE REVIEW
Selecting an ultrasound image with key operation / trackpad.
*In case of standard settings.
Pressing / Swiping to the right: Newer image is displayed.
(The frame numbers on the monitor display become larger.)
Pressing / Swiping to the left: Older image is displayed.
(The frame numbers on the monitor display become smaller.)
1.
Press the MEASURE key to display the measurement screen on the touch panel.
2.
A measurement mark (starting point) is shown in the center of the ultrasound image.
3.
Swipe the trackpad to move the measurement mark to the starting point of distance measurement.
4.
Press the SET key or tap the trackpad to set the location of the starting point. A second measurement mark (ending
point) is displayed near the starting point.
Distance Measurement
Enter Comments
1.
When the COMMENT key is pressed, the touch panel switches to the comment input
screen, and the cursor mark appears on the screen.
2.
Swipe the trackpad, and move the cursor mark to the location where you want to
enter the comment.
3.
Use the keyboard buttons on the touch panel to enter the comment.
4.
Pressing the COMMENT key decides the comment.
The registered comment buttons appear in the upper section of the comment input
screen of the touch panel (registered comment display area). Pressing a registered
comment button opens the registered comment on the monitor.
Measurement mark
(starting point)
Measurement line
Measurement
display area
D1: 30.0mm
Measurement mark
(ending point)
Adjust the focus on the FOCUS MENU screen that appears when
you press the FOCUS button on the B ADJUST tab.
Press the AUTO or MANUAL button to select whether to
set the focal position in AUTO or MANUAL mode.
[AUTO]
PRESENT FOCUS, FOCUS NUM, and
FOCUS LOCATION are set.
[MANUAL] Press one of the F1 to F12 buttons to select the
focal position. Up to two points can be selected.
Adjusting the Focus Number
SET key
Trackpad
MEASURE key
3 Acacia Place, Notting Hill, Victoria, Australia 3168
Customer Service: 1300 132 992 | www.olympus.com.au
28 Corinthian Drive, Albany, Auckland NZ 0632
Customer Service: 0508 659 6787 | www.olympus.co.nz
QR 07.646 V1.0 September 2023
Disclaimer
This sheet is for quick reference only. Please refer to the relevant User’s Manual(s) for instructions, warnings and cautions. Nothing in this presentation is meant to supersede or replace the
instructions for use applicable to each specific device, or the processes and procedures in place at your facility. Quick Reference Guide is only for trained health care professionals.