DMTA-10009-01EN [U8778346], Rev. D, November 2016
Basic Operation
65
b)
Press
[2nd F]
,
[CAL ZERO] (Do ZERO)
.
4.
For a single element transducer, or other dual element transducers, load an
appropriate setup:
a)
Press
[XDCR RECALL]
.
b)
In the menu, select the default choice for the probe type that you use (ex.:
DEFAULT SINGLE ELEMENT
).
c)
In the
DEFAULT
screen for the type of probe that you are using (see the
example shown in Figure 5-3 on page 65), in the list of available default
setups, highlight the setup for the transducer that you are using.
Figure 5
‑
3 Selecting a default single element transducer setup
D E F M 1
-
2 0 . 0 / M 1 1 6
Probe part number (ex: M116)
Probe frequency (ex: 20.0 MHz)
Mode: 1, 2, 3
Material: M
-
Metal, P
-
Plastic
DEF: Default
Default setup naming convention
:
Содержание 38DL PLUS
