Olympic 820, Руководство пользователя, Страница: 9 / 11

[9]
Troubleshooting
Trouble Probable Cause Remedy
Vibration Bent propeller Straighten and balance propeller
Drive shaft installed improperly Check that the universal joint forks are in the same plane
(bearing holes in the same direction)
Drive shaft has not been balanced Have drive shaft dynamically balanced
Engine output shaft and drive input shaft
are not parallel Adjust engine mount so that shafts are parallel
Worn drive shaft universal joints Check condition of universal joints
Inadequate stiffness for drive mounting Stiffen hull mounting flange and hull bottom
Engine mounting loose Tighten engine mounts
Steering wheel locked Low on oil Check tank oil level. Inspect for broken oil lines and loose fittings
Pump not operating
Filter clogged
Air leak in suction line
Repair pump
Replace filter element
Check fittings and tighten where required
Suction hose collapsed Replace suction hose
Lower unit does not steer Obstruction jamming lower unit Remove obstruction
Steering motor key on output shaft
sheared Remove motor and replace key
Oil pressure gauge does not
respond at above 1000 RPM Low oil level Add oil to maintain proper level
Pump not operating Repair pump as required
Oil leakage Inspect for broken oil lines and loose fittings
Oil pressure gauge indicates
excessive pressure Filter clogged Replace filter element
Pinched or obstructed oil line Remove obstruction
Oil level drops Oil leakage Inspect oil lines and fittings
Propeller shaft seal damaged Inspect and replace propeller shaft seal if required
Propeller does not turn Shear pin broken Replace shear pin
Oil discoloured Water leakage Inspect and replace propeller shaft seal
Tighten lower housing bolts
Inspect and replace vertical housing O-Ring seal