Olympia A 4040, Руководство пользователя

Страница: 16 / 49

16
Cold Laminating
1 Connect the power cable to an easily accessible, standard electrical
socket.
Caution: Check that the voltage specifications of the unit correspond
to that of your power supply network (220 - 240 V, 50 Hz).
2
Switch on the On/Off switch on the top, right-hand side of the unit
(I).
3 The drive motor for the transport rollers starts up, the red and green
indicator lamps (POWER and READY, respectively) light up.
Caution: If the laminator was switched to hot laminating shortly
before, allow it to cool down. The equipment takes about 60 minutes to cool
down.
4
Remove the protective foil from the pouch.
5 Insert the document to be laminated in the pouch so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
6 Insert the foil containing the document in the laminator's insertion slot.
Insert the ready closed side of the foil first.
Note: To prevent the laminating foil from creasing, never insert the
open end of the pouch in the insertion slot of the laminator first. When
inserting the foil, observe the instructions on the insertion slot. The
laminating process occurs automatically.
Clearing Foil Jams
The laminator is provided with a "Jam Release" function in order to clear foil
jams quickly.
1
If the foil jams, switch the equipment off and set the switch on the right
top side of the unit to its "REW" position.
2 Hold the laminator firmly and pull the foil together with the document
to be laminated out of the laminator's insertion slot.
3 Set the switch on the right top side of the unit to its "FWD" position.
4 It will probably be necessary to then clean the unit several times as
described in the Section "Cleaning and Servicing".
5 If foil jams occur repeatedly or jammed foil cannot be removed from
the laminator, please contact our hotline.