14
Hot Laminating
1
Connect the power cable to an easily accessible, standard electrical
socket.
Attention:
Check that the voltage specifications of the unit corre-
spond to that of your power supply network (220 - 240 V, 50/60 Hz).
2
Switch on the On/Off switch on the right-hand side of the unit:
HOT
.
The control lamp on the sliding switch lights up red.
3
The drive motor for the transport rollers starts up. The correct operat-
ing temperature is reached after about 4 minutes and the red indicator
lamp turns blue.
4
Insert the document to be laminated in the foil pocket so that there is a
margin of approx. 3 - 5 mm to the edge of the foil on all sides.
Attention:
Only use hot laminating pockets.
5
Insert the foil pocket containing the document in the laminator's inser-
tion slot. Insert the ready closed side of the pocket in first.
Note:
To prevent the laminating foil from creasing, never feed the
open side of the laminating pocket first in the insertion slot of the lami-
nator. When inserting the foil, observe the instructions on the insertion
slot. The laminating process occurs automatically.
Attention:
The foil is very hot and soft when ejected following lamina-
tion. Therefore, handle the laminated product with extreme care.
Note:
To flatten the laminated product, place a book or similar heavy,
flat object, on it.
Cold Laminating
1
Connect the power cable to an easily accessible, standard electrical
socket.
Attention:
Check that the voltage specifications of the unit corre-
spond to that of your power supply network (220 - 240 V, 50/60 Hz).
2
Switch on the On/Off switch on the right-hand side of the unit:
COLD
.
3
The drive motor for the transport rollers starts up, the red indicator
lamp in the sliding switch lights up.
Attention:
If you have just finished using the laminator for hot laminat-
ing, you must let the laminator cool down. The equipment takes about
30 minutes to cool down.
Содержание A 180
Страница 2: ...2...
