Olympia 500 Series, Руководство пользователя, Страница: 11 / 34

Delivery Procedure
Version 10/2020 11
Do not operate your OLYMPIA 500
with the blade protector on the blade.
3.3 How to install the blade
4. The blade holder is located on the underside of the resurfacer.
Check to determine the mating surfaces are free of any foreign
matter. The blade and the blade holder should be covered with a
light coating of oil before installing the blade to prevent rust.
a. Raise the OLYMPIA 500 off the floor.
b. Place two short blocks behind the conditioner and place the
sharpened blade on blocks and then slide the blocks and
blade into the appropriate position for installing.
c. Bolt one end of the blade to the blade holder (finger tight)
and then bolt the other end to the blade holder (also finger
tight). Then install the rest of the bolts and nuts finger tight.
d. After all the bolts are in place, start in the center of the blade
and tighten the bolts and nuts with wrenches working your
way to the outside. You can start at one end and work your
way to the opposite end.
THE BOLTS MUST BE TIGHTENED CONSECUTIVELY.
Do not use lock washers as they will
damage the blade holder.