The light source of this luminaire is not replaceable when the light source reaches its end of
life the whole luminaire shall be replaced.
ATTENTION!!!
CAUTION : Do not view directly with bare eyes.
X 1
8 0
1
A
F
E
SLL-1001/WP & SLL-1003/WP
WATERPROOF SELFTESTING
MAINTAINED/NON MAINTAINED
EMERGENCY LUMINAIRES
IP
65
923
100300
_0
9
_010
923
100300
_0
9
_010
4
5
NOTE:
LED= Light Emitting Diode
LABELING EXPLANATION:
X:
Self contained
1:
Maintained operation
(*)
A:
Including test device
E:
With non-replacable lamp(s) and/or battery
F:
Automatic test gear complying with IEC 61347-2-7 denoted EL-T
90:
1.5 hour duration
180:
3 hours duration
(*)
Maintained operation: The luminaire lights its illumination source, when it is powered by the
mains power supply or not
.
Non Maintained operation: The luminaire lights its illumination source,
only in mains power supply’s
failure.
SLL-1001/WP
SLL-1003/WP
220-240V AC
/ 50-60Hz
11W / 11.4VA
2
2
0.5mm - 2.5mm
23V
375mA
5.3W
23V
52mA
SLL-1001/WP
SLL-1003/WP
Olympia Electronics S.A
.
13.3-14.3V DC
5.3W
1603195
Fixed connection between main pcb and led module
65 °C max. across the board
Warranty
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the technical
instructions included in official documents given by Olympia Electronics or if the buyer modifies the
goods provided or has any repairs or re-setting done by a third party, unless Olympia Electronics has fully
agreed to them in writing.
Products that have been damaged can be returned to the premises of our
company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not
charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not
the buyer the transportation cost.
European
manufacturers
72
nd
km
.
O
.
N
.
R
.
Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
www.olympia-electronics.gr
Non
maintained
NM
Thank you for your trust in our products
Olympia Electronics - European manufacturer
Light output
1000lm
1.5h
Duration
3h
Duration
Maintained
Μ
Warranty
Technical Characteristics
LED Characteristics
MANUFACTURER
MODEL NUMBER
VOLTAGE RANGE
CONNECTIONS
NOMINAL POWER
TEMPERATURE (tc)
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
4.8V/
3
Ah
4.8V/6Ah
1000 - 1350mA
5.7V / 40mA
360 - 410mA
0.94
BATTERY (Ni-Cd)
INSULATION BETWEEN SUPPLY & CONTROL TERMINALS
INSULATION BETWEEN SUPPLY & BATTERY CIRCUIT
MINIMUM POWER FACTOR
WIRE CROSS SECTION
MAX OPEN CIRCUIT VOLTAGE
Irated
Prated
U-OUT
SUPPLY CURRENT
Basic insulation
Basic insulation
BATTERY PROTECTION
3 hours
1
.
5
hour
30
white
LEDs
CHARGE TIME
MINIMUM DURATION
LIGHT SOURCE
24 hours
LED Charge, Lamp Fault LED, Battery Fault LED
700lm / 1000lm
LIGHT SOURCE LUMINOUS FLUX (MAINS / EMERGENCY)
INDICATIONS
MAX CHARGE VOLTAGE
TRICKLE CHARGE VOLTAGE/CURRENT
MIN MAX. CHARGE CURRENT
MIN MAX. DISCHARGE CURRENT
MIN MAX. DISCHARGE VOLTAGE
4 - 6V
6V
Deep discharge and overcharge protection / the control gear will recharge the battery normally after the test of 22.3
IP65
DEGREES OF COVER PROTECTION
EN 60598-1, EN 60598-2-22, ΕΝ 55015,
ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
PRODUCED IN ACCORDANCE WITH
OPERATION TEMPERATURE RANGE
CONTROL GEAR MAX.TEMPERATURE: tc
o
5
to 40 C
o
74 C at Z3
ABS/PC
,
PC
1030gr.
1306gr.
322 x 162 x 58 mm
RELATIVE HUMIDITY
CONSTRUCTION MATERIAL
EXTERNAL DIMENSION (L x W x H)
WEIGHT
GUARANTEE
Up to 95%
3 years
(1
year for the battery
)
CONTROL GEAR WITH AUTOMATIC
TEST FUNCTION