Page
4 from
5
923473001
_0
9
_00
1
SURFACE MOUNTING
1
2
5
4
Other
possible
Cable entry
holes
1. Detach the front cover by applying pressure using a flat blade screw driver. Next, unfasten the four
retaining screws without removing them and remove the diffusor.
2. Use a drill with a 3,5mm bit to open the 4 mounting holes (figure 2) located in the plastic base..
3.
Place the luminaire on the desired mounting location and mark and drill these 4 holes. Fit the
supplied 4 plastic mounting plugs to these drilled holes on the mounting location.
4.
If the cable entry hole is not suitable then use one of the supplied cables grommets to cover the
holes and open another cable entry cut out hole (figure 3). Follow step 3 of the “
initial installation
procedure
”.
5.
Mount the base to the desired location by using the supplied screws in each mounting
hole(figure 4)
.
6
.
Re-install the cover that was removed in step 1.
MOUNTING IN SUSPENDED CEILING
10
